AFTER SALES SUPPORT
Email: service@prolinkasia.com
Phone: 0508 776 546 - Mon-Fri 8:30am – 4.30pm Page 12
TIMER
Use the timer to turn on and off the appliance automatically.
When the Dehumidifier is turned on, press the timer button to program the time
you wish the unit to turn off. Each press of the button will change the timer by 1
hour. The unit will automatically switch off after the pre-selected time.
If you want to cancel the timer programming, press the timer button to
adjust the time at 00.
When the dehumidifier is turned off, press the timer button to set the time you
wish the unit to turn on. Each press of the button will change the timer by 1 hour.
The unit will automatically switch on after the pre-selected time.
If you want to cancel the timer programming, press the timer button to
adjust the time to 00.
The programmed time remains unchanged if the machine stops working due to water
full or during defrost mode.
HUMIDITY
Press the humidity button to check the current environmental humidity, press this
button again to set the humidity.
The range of target humidity is 30%- 80%. In 5% increments.
If no button is pressed after 3 seconds, the system confirms the input value and
then returns to the current humidity. In the continuous drying mode, the target
humidity cannot be changed.
Long Press the humidity button for 3 seconds to display the current ambient
temperature.
FAN
High speed - low speed, press the button once to cycle fan speed, the corresponding
indicator lights up.
In continuous drying mode, sleep mode and during defrost, the wind speed cannot be
changed.
CHILD-LOCK
Press and hold 3 seconds to turn on/off the child lock function.
DRAINAGE
There are two ways of removal collected water produced by the unit.
a) Manual draining: Emptying the water tank manually.
b) Continuous draining: connect a drain hose allowing captured water to flow
out.
To Next Page
Loading...
