EasyManua.ls Logo

Sheffield PL618 - Instructions

Sheffield PL618
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AFTER SALES SUPPORT
Email: service@prolinkasia.com
Phone: 0508 776 546 - Mon-Fri 8:30am 4.30pm Page 11
Make sure the Water tank is correctly fitted otherwise the unit will not operate.
The dehumidifier will start in the mode selected when the unit was last used.
The dehumidifier starts dehumidifying if the room humidity is 3% higher than the
selected humidity.
There is a protective 3-minutes time delay of the compressor. If turned off wait 3
minutes before turning it back on.
INSTRUCTIONS
Using Your Dehumidifier
POWER
In the standby state, press the power button to turn on, the operation indicator lights
up and the default fan speed is high, and the default humidity is 50%. In the power-on
state, press the power button to turn off, the running indicator light goes off and the
compressor stops immediately, and then the fan shut down after 30 seconds delay.
MODE
Auto mode - continuous drying mode-sleep mode
Press to cycle the mode from one to another, the corresponding indicator will light up.
Auto mode:
when the environmental humidity ≥ set humidity (+3%), the fan
starts working and the compressor starts working after 3 seconds. When
environmental humidity ≤ set humidity (-3%), the compressor stops working and
the fan stops working after 30 seconds’ delay.
Both fan speed and humidity can be adjusted under auto mode.
Continuous drying mode:
The machine will run, but the humidity cannot be
adjusted.
Sleep mode:
Press the sleep button, the button lights up and starts the sleep
function. After no operation in 10 seconds, all indicators gradually turn dark and
the fan speed is automatically switched from high to low. Press any button to
wake up the indicator. Press the sleep button again to exit the sleep mode.
When the environmental humidity ≤ 57%the compressor will stop
working and the fan shuts down after 30 seconds’ delay.
When the environmental humidity ≥ 63%the fan starts to work and
the compressor will start working after 3 seconds.
The fan speed and humidity cannot be adjusted under sleeping mode.

Related product manuals