Shell newmotion Home Advanced Edition 7 - Local Configuration Settings; Power Setting Configuration; Dynamic Power Management Setting; Start Charging Setting

INSTALLATIEHANDLEIDING – P14 VERSION 0129NM02INT01 INSTRUCTION MANUAL – P14 | P14 07A2NM20ENG05
The Home Advanced Edition can be congured locally
using the Home Charging by NewMotion app.
Three items are required for local conguration:
1. Charge point which is installed and on power
2. QR Code for WiFi connection
3. Home Charging by NewMotion app
Make sure that the charge point is powered on for at
least 5 minutes.
TIP: Make sure to have the Home Charging by
NewMotion app already installed on your smartphone,
before installing the charge point.
- Open the Home Charging by NewMotion app
on your phone
- Follow the steps as described in the Home Charging
by NewMotion app
- Use the QR Code for WiFi connection, which is
included in the charge point package, when the Installer
App requests to scan a QR Code
6.1 POWER SETTING
Select the maximum allowed current for the installed
circuit. Taking into account the MCB, RCD, grid
connection and local regulations.
6.2 DYNAMIC POWER MANAGEMENT
SETTING
Enable Dynamic Power Management if upstream
Dynamic Power Management module is installed.
When Dynamic Power Management is enabled, ll in
the maximum current of the grid connection as the
installation max current.
6.3 START CHARGING SETTING
Set whether the charge session will be started
automatically after connecting the cable and car (default)
or using an RFID charge card.
6. LOCAL CONFIGURATION