Shell SH924 User Manual

2. A) Once clamps are properly connected, the green LED jumper cable
indicator will turn solid from flashing. You may now try to start your vehicle.
B) Otherwise please refer to the following jump start troubleshooting
table for corresponding solutions.
1. Connect the red battery clamp to the positive (+) terminal and the black
battery clamp to the negative (-) terminal on your vehicle’s battery.
Note: Required capacity to jump start a vehicle
1
3. After the engine starts, disconnect the battery clamps from the battery
terminals.
LED Battery
Level Indicator
Battery Capacity Indications
Best condition to jump start
a vehicle
The minimum capacity
required to jump start a vehicle
Recharge the jump starter
before use
75% - 100%
50% - 75%
25% - 50%
0% - 25%
Connecting to the vehicle battery

Shell SH924 Specifications

General

Brand	Shell
Model	SH924
Category	Remote Starter
Language	English