What to do if the LED light is flashing 4 times per second on Shell SH924 Remote Starter?
If the LED light on your Shell Remote Starter is off and flashing four times per second, it indicates over-temperature protection has been activated. To resolve this, disconnect the clamps from the vehicle’s battery and allow the jump starter to cool down in a cool, ventilated area.
How to fix Shell SH924 when LED light is solid green and off?
If the LED light on your Shell Remote Starter is solid green and off, it may indicate that the vehicle needs a jump start. Please jump start the vehicle.
Why is the LED light off and flashing on my Shell SH924?
If the LED light on your Shell Remote Starter is off and flashing, this indicates low battery protection. Please charge the jump starter.
What to do if LED Light is Flashing on Shell SH924?
If the LED light on your Shell Remote Starter is flashing, it means the clamps are not connected to the battery. Disconnect and reconnect the clamps to the battery.
What does it mean when the LED Light is Off and On on Shell SH924 Remote Starter?
If the LED light on your Shell Remote Starter is off and on, it indicates reverse polarity or short-circuit protection. Disconnect the clamps from the vehicle’s battery, then follow the jump starting instructions to jump start the vehicle.
Instructions for connecting the DC adapter and charging the jump starter using AC power.
Guide on how to use the jump starter to start a vehicle's engine.
Information on battery levels and capacity needed for jump starting a vehicle.
Detailed steps for connecting the jumper cable clamps to the vehicle battery terminals.
Advice on personal protective equipment and handling procedures around vehicle batteries.
Instructions for the proper recycling or disposal of the product's rechargeable battery.
General| Brand | Shell |
|---|---|
| Model | SH924 |
| Category | Remote Starter |
| Language | English |
To Next Page
