ATTENTION!
WARNING
2. SAFETY
• install current leads with the device switched off, • do not touch
non-insulated parts of the electrode holder, electrode and workpiece at the same time
Prevention of electric shock: • connect the
device to a technically efficient electrical installation with proper protection and zeroing efficiency (additional
protection against electric shock); other devices at the welder's workplace should also be checked and
properly connected to the network,
• VAPOR AND GAS POISONING •
BURNS •
EXPLOSION AND FIRE HAZARDS • NOISE
Any modifications to the rectifier are prohibited and void the warranty.
Damage to the device caused by improper handling will void the warranty.
Due to the continuous technical development of the device, some of its functions may be modified and their
operation may differ in detail from the descriptions in the manual. This is not a device error, but the result of
progress and continuous modification work on the device.
During MIG/MAG electric welding, there are the following risks: • ELECTRIC SHOCK
• NEGATIVE EFFECT OF THE ARC ON
HUMAN EYES AND SKIN
Start-up and operation of the device can only be carried out after reading these Operating Instructions carefully.
Therefore, special precautions must be taken when welding. Before welding, familiarize yourself with
the health and safety regulations in force at the workplace.
deletion,
1. GENERAL NOTES
Welding can endanger the safety of the operator and others in the vicinity.
• It is forbidden to operate the device with the covers removed.
Preventing the negative impact of the electric arc on human eyes and skin: • Use protective
clothing (gloves, apron, leather shoes), • Use protective shields or
visors with a properly selected filter,
Please read this manual before installing and commissioning the device
• know the health and safety rules when handling cylinders and installations with compressed
gas (argon), • know the content of this manual and use the device in accordance with its intended use.
• do not use holders and current leads with damaged insulation, • in
conditions of particular risk of electric shock (work in environments with high humidity and closed tanks) work
with an assistant supporting the welder's work and ensuring safety, wear clothes and gloves with good
insulating properties, • in the event of noticing any irregularities, contact competent persons for correction
Employees operating the device should have the necessary qualifications entitling them to perform welding
works: • they should have electric
welder qualifications in the field of welding in gas shields, • know the health and safety rules when
operating electrical power equipment, such as welding devices and auxiliary equipment powered by electricity,
welded, including the device housing,
2
Machine Translated by Google
To Next Page
