16
13. MAINTENANCE INSTRUCTIONS
As part of the everyday operation of the welder must be kept clean, check the connection status and the status of external electrical wires
and cables. Regularly replace consumables.
Periodically clean the inside of the device by purging with compressed air to remove dust and chips from metallic plates, and the control wires and
electrical connections. Not less than once every six months should be a general review of the status and electrical connections, in particular:
- state of shock protection
- the insulation
- the state security
- the operation of the cooling system
Damage resulting from the welding operation in unsuitable conditions and failure of recommendations for maintenance are not covered by
warranty repairs.
14. INSTRUCTION STORAGE AND TRANSPORT
The device should be stored at -10 ° C to + 40 ° C and relative humidity 80% free of corrosive fumes and dusts. Transportation of packaged devices
should be covered means of transport. For transport the packaged unit must be secured against slipping and ensure the correct position.
15. COMPLETE SPECIFICATION
1. Source DIGITIG 200AC / DC MULTIPRO 1 piece.
2. Holder for TIG welding 1 piece.
3. Electrode wire 1 piece.
4. Earth cable with a clamp 1 piece.
5. Manual 1 piece.
6. package 1 piece.
16. ELECTRIC SCHEME
To Next Page
