ENGLISH
27
LISTENING TO RADIO BROADCASTS
Auto tuning
• Each time this button is pressed, the band changes as
follows :
→ FM ST → FM MONO
(“ST” lights up) (“ST” goes off)
• When FM stereo broadcasts are poor because of weak
broadcast signals, select the FM mono mode to reduce
the noise, then FM broadcasts are reproduced in
monaural sound.
• Manual tuning is useful when you already know the
frequency of the desired station.
• After selecting the desired band, press the TUNING
buttons repeatedly until the right frequency has been
reached.
Manual tuning
• Auto presetting function automatically searches for FM
stations only and store them in the memory.
• While listening to FM radio broadcasts, press and hold
down the ENTER button for more than 2 seconds.
• Then “AUTO MEM” flickers and this receiver starts auto
presetting.
• To stop auto presetting, press this button again.
• Up to 30 FM stations can be stored.
■Notes:
• FM stations of weak strength cannot be memorized.
• To memorize weak stations, preform “Manual presetting”
procedure with using “Manual tuning” operation.
Auto presetting
1. Select the desired band.
2. Press the TUNING buttons for more than 0.5
second.
• The tuner will now search until a station of sufficient
strength has been found. The display shows the tuned
frequency and “TUNE”.
• If the station found is not the desired one, simply repeat
this operation.
• Weak stations are skipped during auto tuning.
R-904(G)_ENG_091014:R-904(G) 2009-11-11 오후 12:05 페이지 27
To Next Page
Loading...
Need help?
General