Shibaura SG280E - Safe Driving and Work Practices

27
2727
27
DRIVING AND WORK
4. Starting, Turning and Stopping Method
● When starting the vehicle, check for
people
around the vehicle, confirm safety in the
surrounding areas and start the vehicle
slowly avoiding an abrupt start.
Failure to
do this may result in injury or
may cause
accidents.
●
During operation or when moving the
vehicle, wear a helmet for safety.
●
Do not allow anybody other than the driver
to get on the vehicle.
●
Do not start, turn or stop the vehicle
abruptly
or do not drive the vehicle too fast.
Operate it slowly.
①
①①
① Starting
(1)
Shift the gear shift lever to a desired
position.
(2) Lift the mower with the lifting lever.
(3) Push down the parking brake pedal
to
release the parking brake.
(4) By pressing forward
or reverse pedal, the
vehicle starts moving.
[Caution for Handling]
● Stop the vehicle before moving the
gear
lever. Operating the lever while the vehicle
is moving may cause a failure.
②
②②
② Turning
●
Before turning the vehicle, decrease the
speed s
ufficiently. If the vehicle turns at a
high speed, it may turn over and an injury
accident may result.
● When making a
turn, ascertain the ground
condition before turning.
③
③③
③ Stopping and Parking
●
When you leave the vehicle, park it on solid,
flat and stable ground.
●
If you are required to park the vehicle on a
slope, park the vehicle
sideways and apply a
chock to the front wheels.
(1) Release your foot from the
forward or
reverse pedal and press the brake pedal.
(2) Lower the implement fully.
(3) Apply the parking brake.
5. Work Operation
● Remove obstacles in the
area to be cut
before commencing work.
Obstacles may
damage the mower and the vehicle, as well
as the mower blade.
● Do not run
the mower in raised condition. It is
dangerous and
may damage the mower
body.
● Do not direct the discharge
outlet to people.
Grass or stones may be discharged
and
injure them.
Warning
Warning
Warning
Warning