SECTION 4 – SXM54, SXM60 MOWER DECK
4-24
REMOVAL AND STORAGE
For Removal and Installation procedure of the
SXM54 and SXM60 mower decks, see
"Mounting" and "Dismounting" sections in this
chapter.
SEASONAL STORAGE
Proper off-season storage is critical for operation
and performance of the mower deck when
reinstalled on the tractor in preparation for the
mowing season. Follow the steps listed for
storage over the off season.
1. Remove the deck from the tractor.
2. Clean the entire mower deck of dried grass
clippings, especially the underside of the
deck.
3. Remove, sharpen or replace the mower
blades.
4. Inspect, or replace the deck beIt. (Relieve
the belt tension by removing the belt from the
idler pulley during storage)
5. Inspect the entire mower deck for damaged
or worn parts. Make replacements as
necessary using genuine SHIBAURA service
parts.
6. Service the mower deck as described in the
"LUBRICATION" section, and re-torque all
fasteners according to the information found
in the "TORQUE SPECIFICATIONS".
7. Clean all pulleys with a dry cloth and apply a
very light film of oil on the pulleys.
NOTE: Leave the drive belt slack. Clean pulleys
and re-install the drive belt just prior to placing
mower into service.
8. Touch-up the paint where necessary to
prevent rust or corrosion.
9. Replace all damaged or illegible decals.
10. Store the mower in a clean and dry location.
If the mower deck is to be stored outdoors,
cover it with a leak proof tarp.
To Next Page
Loading...
