SECTION 2 – OPERATION
2-10
Flasher Warning Lights
The four flasher warning lights ① are controlled
by the upper switch lever ③ on the rotary
selector switch ② located to the left of the
steering column. Move the switch lever clockwise
to turn the flashers ON. Return the switch lever
counterclockwise to turn the flashers OFF.
Flasher Turn Lights (Turn Signals)
The turn signal lights are controlled by the lower
switch lever ⑤ on the rotary selector switch ②
located to the left of the steering column. Move
the switch lever to the right to indicate right turns,
and to the left for left turns. (The ignition key
must be in the "ACC/RUN" position for the turn
signals to operate.)
When signaling a turn, the designated turn side
amber light will flash, and the opposite side
amber light will illuminate continuously.
NOTE: If the turn signal is actuated while the
flasher warning (Hazard) lights are operating, the
amber light on the side opposite the turning
direction will stop flashing and illuminate
continuously.
Horn
To activate the horn, push in on center button ⑥.
Horn can be activated with the key switch in any
position.
To Next Page
Loading...
