EasyManua.ls Logo

Shibaura SX21 - Page 83

Shibaura SX21
133 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SECTION 4 – SXM54, SXM60 MOWER DECK
4-4
OPERATING THE TRACTOR & MOWER
Use the hand holds and step platforms when
mounting and dismounting the tractor to prevent
falling. Always keep steps and platforms clean
and free of mud or other debris.
The operator MUST remain in the tractor seat at
all times while mowing, transporting, or anytime
the tractor engine is running.
NEVER start the engine while-standing beside
the tractor. The operator MUST sit in the tractor
seat when starting the engine.
NEVER run the engine in a closed building
without adequate ventilation. Exhaust fumes are
very dangerous and can cause permanent injury
or death.
Use extreme care when operating on slopes to
maintain equipment stability.
Keep the tractor in gear when traveling downhill.
Install tractor wheel weights to increase stability
when operating on slopes. Consult your
SHIBAURA Dealer on ballasting requirements for
your equipment.
To avoid loss of control, and to prevent
over-turning the tractor and mower, always mow
up and down slopes, never across. DO NOT
operate on steep slopes.
Always bring the tractor to a complete stop,
lower the mower deck to ground contact,
disengage power to the mower, set the parking
brake, shut off the engine and remove the key,
before dismounting from the tractor.
NEVER park the tractor on an incline.
SERVICING THE MOWER
Keep the tractor and mower clean. Grease, dry
debris and grass buildup can cause fires,
damaging the equipment and causing serious
injury to yourself or others.
Check for and replace or repair missing, loose, or
damaged parts on the mower. A defective mower
could cause injury to another operator who is
unaware of a potential problem.
To avoid injury, do not clean, adjust, unclog, or
service the mower when the engine is running.
Do not work under the raised tractor or mower
deck unless it is securely supported by a hoist,
floor jack and jackstands.
Make sure all hoists, floor jacks and jackstands
are in good working order and have sufficient
capacity to support the elevated equipment,
before repair, adjustment, or lubrication of the
tractor or mower.
Inspect the mowing blade retainer nuts daily, or
whenever a blade has been removed. Torque is
150 - 177 N·m. These nuts have right hand
threads.
To avoid injury when handling mowing blades,
wear leather gloves, or wrap the blades in the
area where they will be held.
Do not modify or alter or permit anyone else to
modify or alter the mower, or any of its
components or operating functions. If in doubt on
modifications, see your SHIBAURA Dealer.
WHEN YOU SEE THIS SYMBOL
IT MEANS:
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

Other manuals for Shibaura SX21

Related product manuals