Shimadzu MOC63 - User Manual

MOC63 Specification
Accessories list
Safety Precautions
Read Instruction manual and understand before use of this
instrument.
●Use this instrument for measurements in which water
vaporizes from the sample under heating.
●The temperature of the heater installed in this instrument
becomes higher than the set heating temperature for the
sample.
●Any sample that is explosive, inflammable or may cause
hazardous reaction under heating must not be measured
with this instrument.
C000-E0000
Optional accessories
Printer EP-80
Printer EP-90
Protection cover(5pieces)
Aluminum sheet
Fiberglass sheet
Temperature calibration kit
Sample pan (SUS)
RS-232C cable
USB connection cable
Heater
1
2
3
4
5
6
7
8
9
10
Standard accessories
Sample pan
Aluminum sheet
tongs
In use protection cover
Fuse
1
2
3
4
5
Max
Min
Capacity
Minimum readability
Repeatability
Drying Heater
Power
Setting temperature
range
Display
Pan size
Dimension(W×D×H)mm
Weight
Operational temperature
and humidity range
Measurement mode
Timer setting
Interface
Measurement condition
data memory
Data memory
Temperature calibration kit
60 g
0.02g
0.001g
0.01/0.1%(Selectable)
0.15% (2g)
0.05%(5g)
0.02%(10g)
Straight type halogen lamp
400W
50〜200°C (1°C increments)
(There is time restriction on more than 180°C.)
LCD with Backlight
Φ95mm
200×330×175
Less than 6kg
5 to 40°C 85%RH or lower
Standard mode
(Automatic start/Automatic end/Timed end)
Rapid drying mode
(Automatic start/Automatic end/Timed end)
Slow drying mode
(Automatic start/Automatic end/Timed end)
Step drying mode
(Automatic start/Automatic end/Timed end)
1-120 minutes or continuousness
(max 12 hours).
RS-232C(9-pin connector)I/O port
USB (factory option)
10
50
Option
UniBloc Moisture AnalyzerUniBloc Moisture Analyzer
MOC63
ダミー
ダミー

Shimadzu MOC63 Specifications