Need help?Do you have a question about the Shimano Steps SW-EM800-L and is the answer not in the manual?
General| Position | Left |
|---|---|
| E-Tube Port | 0 |
| E-Tube Connector | 1 |
| System On/Off | Yes |
| Assist Level Change | Yes |
| Walk Mode | Yes |
| Connection Type | Wired |
| Functions | System on/off, walk mode |
| Mounting | Handlebar |
| Motor Type | EP8 |
| Clamp Band Diameter | 22.2mm |
Details the classification of instructions by danger level (DANGER, WARNING, CAUTION).
Provides instructions for safe installation, maintenance, and general usage of the product.
Offers precautions for users regarding product use, modification, cleaning, and general handling.
Lists specific SHIMANO tools and general tools needed for product installation and maintenance.
Introduces the EW-SD300 and EW-SD50 electric wires and their supported products.
Instructions and notices on how to correctly connect and disconnect electric wires without damage.
Guides on setting the electric wire plug to the TL-EW300 tool, aligning tabs.
Instructions for inserting the electric wire plug into the E-TUBE port until it clicks.
Step-by-step guide for removing the EW-SD300 electric wire using the TL-EW300 tool.
Guides on setting the electric wire plug to the TL-EW02 tool, aligning with groove.
Instructions for inserting the electric wire plug into the E-TUBE port for EW-SD50.
Step-by-step guide for removing the EW-SD50 electric wire using the TL-EW02 tool.
Warning about installing Junction [A] to avoid frame damage if the bike tips over.
Warning to ensure the cable cap does not interfere with the brake lever.
Warns against unnecessary adjustment that may worsen performance or cause falls.
Guides on navigating to [Adjust] to check the current setting value.
Steps to adjust the setting value one step at a time using directional buttons.
How to select [OK] to set the adjusted value and return to the basic screen.
Advise to test gear shifting after adjustment to confirm changes.
How to adjust value further if symptom improves or remains unchanged.
How to adjust value in the opposite direction if symptom worsens.
Return to basic screen and check symptoms after making adjustments.
Ride the bicycle to confirm that abnormal noise or feel has been resolved.
Guides on setting the value to [0] before adjusting if it's not already zero.
Steps to return the setting value to [0] using Junction [A] and buttons.
Perform gear shifting and confirm changes, referring to previous adjustment steps.
Ride the bicycle to confirm resolution of abnormal noise or feel.
Warns against unnecessary adjustment that may worsen performance or cause falls.
Step to shift to the fifth gear position from the largest sprocket.
How to hold the button to activate adjustment mode with LED1 lighting up red.
Moving the guide pulley to contact the fourth gear position with subtle noise.
Moving the guide pulley five steps to the smallest sprocket side as a standard.
Pressing the button to finalize adjustment and return to normal mode.
What to do when the cycle computer or junction [A] shows an error indication.
To Next Page
