8
Maintenance
Replacing the pins
Maintenance
Replacing the pins
PD-GR400
If the pins become worn or damaged, replace them with new pins.
1. Replace pins as shown in the figure.
1 - 1.5 N·m
Pin
Adjusting axle bearings
Adjustment is required if the rotating parts are not functioning properly. Follow the procedures
shown below.
PD-EF202/PD-EF205
1. Remove the cap using a tool such as a slotted screwdriver.
Cap
2. Use the TL-PD400 SHIMANO original tool to turn the cone to adjust the
bearing preload.
To Next Page
Loading...
