28
Junction [A] (EW-EN100)
EW-EN100 is used instead of cycle computer.
It is attached to the brake outer casing or brake hose and located near the handle bar.
Button
Junction [A]
Button
Press: change the assist mode each time you press it.
Press and hold (about 2 seconds): turn the light ON/OFF
NOTE
• To change to walk assist mode, a switch unit is required.
• The button does not recommend operating this unit while riding the bicycle. Please select your preffered assist mode before riding.
• For other functions assigned to the button, see "Setting (EW-EN100)."
To Next Page
Loading...
