Shimano STEPS E8000 Series - Switching between Displayed Traveling Data

27
 Switching between displayed traveling data
The type of traveling data displayed changes each time
you press A.
A
SW-E8000-L/SC-E8000
A
SW-E6000/SC-E6010
Holding down A when DST is displayed clears all traveling
data.
(A) Traveling distance
(B) Cumulative distance
(C) Maximum traveling distance *1, 3
(D) Traveling time (optional) *2
(E) Average speed (optional) *2
(F) Maximum speed (optional) *2
(G) Number of crank rotations *2
(H) Pedaling force (Human power) *2
(I) Calorie consumption *2
(J) Current time *4
(A) DST CLOCK (J)
(B) ODO CALORIE (I)
(C) RANGE POWER (H)
(D) TIME CADENCE (G)
(E) AVG MAX (F)
*1 When [RANGE] is displayed, the battery level is not displayed. The traveling range should be used as a reference only.
*2 Optional item: You can configure the display settings in E-TUBE PROJECT. For details, refer to the "Connection and
communication with devices." section.
*3 When walk assistance is functioning, the on screen display [RANGE] changes to [RANGE ---].
*4 Displayed constantly on SC-E6010.
NOTE
When traveling data other than POWER or CALORIE is displayed, the screen returns to speed display after 60 seconds.
When speed data is displayed, pressing A changes the traveling data displayed starting with DST.