Need help?Do you have a question about the Shimano SW-EN600-R and is the answer not in the manual?
General| Model | SW-EN600-R |
|---|---|
| Category | Bicycle Accessories |
| Mounting | Handlebar |
| Mount Type | Clamp Band |
| Position | Right |
| Compatible handlebar diameter | 22.2 mm |
| Color | Black |
| Water Resistance | IPX7 |
| Remote Switch | Yes |
| Type | Wireless Remote Switch |
| Compatibility | Shimano Steps |
| Connection | Wireless |
| Material | Plastic |
| E-Tube Port | 0 |
Explains compatibility between first-generation and Gen.2 SHIMANO STEPS components.
Details EW-SD300 and EW-SD50 electric wire types, accessories, and conversion adapters.
Instructions for mounting clamp band, switch unit, and bracket type cycle computers on handlebars.
Procedures for installing various switch unit types (MTB, Standard, I-SPEC EV, 3-switch).
Explains wiring methods for different cockpit configurations, including routing and securing electric wires.
Overview of connecting bicycles to devices for system configuration and firmware updates via E-TUBE PROJECT.
How to connect all SHIMANO STEPS components to a PC for setup and firmware updates.
Instructions for connecting individual components to a PC using a linkage device for configuration.
Guide to backing up and exporting drive unit settings for maintenance and distributor service.
Procedure for removing and installing the clamp band on cycle computer mounts.
Detailed steps for adjusting electronic gear shifting performance using the cycle computer interface.
Information on automatic time correction and its use in system logs and maintenance alerts.
To Next Page
