Shop fox M1049 - Page 37

-35-
D('+09\eZ_kfgCXk_\D]^%J`eZ\/&'0
D8@EK<E8E:<
For daily lubrication, use a manual oil gun with a general
10W machine oil to lubricate the following 13 ball oiler fit-
tings and the 4 oil cups. Wipe off all oil ball fittings with a
rag, and then oil the following locations:
• Gearbox (2 ball oilers on top)
• Gearbox (4 oil cups on top)
• Tailstock (1 ball oiler on top)
• Headstock (2 ball oilers on top)
• Apron (2 ball oilers on apron face)
• Apron (1 ball oiler on top left front)
• Lead Screw End Cap Bushing (1 ball oiler on side)
• Idler Drive Pulley (1 ball oiler on spindle end)
• Change Gear Spindles (3 ball oilers on spindle ends)
=`^li\43%End-cap bushing and tailstock
ball oilers.
=X`cli\ kf ]fccfn clYi`ZXk`fe ^l`[\c`e\j n`cc c\X[ kf
iXg`[[\k\i`fiXk`fef]Y\eZ_kfgcXk_\Zfdgfe\ekj%