ADM-870 05/23/0829
The dowel end pins are inserted into the outer set of frame support cups when assembling a 1'x4' top and into
the inner set when assembling a 2'x4' top as shown in Figures 10.5 and 10.6. The 1'x5' top requires an 8.5"
dowel extender at the bottom of each support dowel. The dowel end pins are to be inserted into the inner set
of frame support cups as shown in Figure 10.7.
The 3'x3' top requires dowel extenders added to both the top and bottom of the support dowels. The dowel end
pins are to be inserted into the frame corner brackets as shown in Figure 10.8.
Each frame piece has been labeled to indicate positioning of the support dowels for different frame sizes. When
the top assembly is complete, the springs on the short rods of the top support assembly should be compressed
to approximately 50% of normal extension.
10.5 HANDLE
Attach the handle assembly to the handle plate using the knob type screw provided with the handle.
SEE THE NEXT FOUR PAGES FOR DIAGRAMS OF CORRECT METHOD OF
ASSEMBLING STANDARD FLOWHOOD TOPS AND FRAME SETS.
To Next Page
Loading...
