8.2. Working with Shows
Show files contain all your show related settings like fixture schedule and patching, input settings, groups,
presets, cues, master assignments, etc. Multiple shows may reside on the console and the number of
shows is only limited by hard disk memory. However, we advise to regularly backup old shows to a USB
key and delete them off the console’s memory.
8.2.1. Create a new Show from the Initial Screen
A Show stores all information like Patch, Fixtures, Groups, Presets, Playback Faders, and so on. To start a
new show as follows:
Within the initial screen, hit the Create New Show button.
A keyboard dialog to enter the name of the show to be created is opened. You may enter the
Name using an attached USB-Keyboard anytime the keyboard dialog is shown.
As soon as you hit the enter button a new show with the given name is created.
Note: If you would like to start a new Show file from within a show, please read the steps below.
You may also create a new Show using the Action Dialog within the Manage Shows tab in the Setup
Menu. Find the step by step for it in: 8.4.4.1 Manage Shows Action Dialog on page 75
8.2.2. Loading a Show
Within the initial screen, simply select the show you would like to open from the list and hit the Open Show
button.
Note: If you would like to open a Show file from within a show, please read the steps below.
You may also load a Show using the Action Dialog within the Manage Shows tab in the Setup Menu. Find
the step by step for it in: 8.4.4.1 Manage Shows Action Dialog on page 75
To Next Page
Loading...
