What to do if my SHOWTEC Lighting Equipment has no light?
If your SHOWTEC Lighting Equipment has no light, it might be due to the power supply settings not matching your local AC voltage and frequency. Disconnect the fixture and check these settings, correcting them if necessary. Alternatively, the lamp might be missing or blown. Disconnect the fixture and replace the lamp.
How to troubleshoot SHOWTEC Lighting Equipment when one or more fixtures are completely dead?
If your SHOWTEC Lighting Equipment fixtures are completely dead, it could be due to a lack of power. First, ensure that the power is switched on and all cables are securely plugged in. If the problem persists, check the primary fuse, and replace it if it's blown.
Why does the lamp in my SHOWTEC Lighting Equipment cut out intermittently?
If your SHOWTEC Lighting Equipment lamp cuts out intermittently, it could be due to the fixture overheating. Allow the fixture to cool down, clean the fan, and ensure that the air vents at the control panel and front lens are not blocked. Improving air conditioning in the area may also help. Another cause might be incorrect power supply settings. Disconnect the fixture and check the settings to ensure they match your local AC voltage and frequency; correct if necessary.
What to do if all SHOWTEC Phantom 300 Spot fixtures respond erratically to the controller?
If your SHOWTEC Lighting Equipment fixtures reset correctly, but all respond erratically or not at all to the controller, it could be because the controller is not connected. Ensure the controller is properly connected. Another cause may be that the 3-pin XLR Out of the controller does not match the XLR Out of the first fixture on the link (i.e., the signal is reversed). In this case, install a phase-reversing cable between the controller and the first fixture on the link.
Why do some SHOWTEC Phantom 300 Spot fixtures respond erratically to the controller?
If your SHOWTEC Lighting Equipment fixtures reset correctly, but some respond erratically or not at all to the controller, it may be due to poor data quality. Check the data quality; if it's much lower than 100%, the problem may be a bad data link connection, poor quality or broken cables, a missing termination plug, or a defective fixture disturbing the link. * Inspect connections and cables, correcting poor connections and repairing or replacing damaged cables. * Insert a termination plug in the output jack of the last fixture on the link if the data link is not terminated with a 120 Ohm termination plug. * Check the address settings for incorrect addressing. * Bypass one fixture at a time until normal operation is regained to identify a defective fixture: unplug both connectors...
General| Pan Range | 540° |
|---|---|
| Tilt Range | 270° |
| Power Supply | 100-240V AC, 50/60Hz |
| Type | Moving Head |
| Gobo Wheel | 7 rotating gobos + open |
| Control Protocol | DMX512 |
| Dimming | 0-100% |
| Strobe | Yes |
| Control | DMX, Sound |
To Next Page