Turn on the equipment, walk on the treadmill slowly for a few minutes, let the running belt being complete
attached of lubricating oil. Increase the speed and lubrication is finished.
Note:Do not put on too much lubricating oil once.
After lubricating, use a cloth to clean up the extra oil on the side and surface of the running belt.
Maintenance Instructions
1. In order to maintain the electric treadmill and prolong the service life of the treadmill, suggest you to
turn off the power after lasting two hours and let the treadmill free for 10 minutes before the usage.
2. If the running belt is too loose, it will slip during the running exercise. If it is too tight, it will lower the
function of electric engine, and wear the roller and running belt severely, and shake the whole machine. If
you want to test if the tightness of the running belt is appropriate, please support the running belt away
from the running board about 50-75mm.
Adjust the running belt to be in middle and suitable tightness.In order to let you use the treadmill better
and more efficiently, it is necessary to adjust the running belt to the best state.
Adjust running belt to be in the middle:
Put the treadmill on the lever ground.
Make the treadmill running in about 3.5KM/H.If the running belt inclines to right side, turn the right
adjustable bolt for 1/2 cycles by clockwise, and then turn the left adjustable bolt for 1/2 cycles by
counter-clockwise. See figure A:
If the running belt inclines to left side, turn the left adjustable bolt for 1/2 cycles by counter-clockwise
clockwise. See figure B:
To Next Page
Loading...
