Shure ANIUSB-Matrix - Page 23

9/12/17, 8)20 AMShure Publications | User Guides | ANIUSB-Matrix
Page 23 of 39http://pubs.shure.com/guide/ANIUSB-Matrix/en-US
ANIUSB Response:
< REP xx CHAN_NAME
{ yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy }
>
Where
yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy
is 31 characters of the user name. The
ANIUSB always responds with a 31
character name.
Get Device ID
Command String:
< GET DEVICE_ID >
The Device ID command does not contain
the x channel character, as it is for the
entire ANIUSB.
ANIUSB Response:
< REP DEVICE_ID
{ yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy }
>
Where
yyyyyyyyyyyyyyyyyyyyyyyyyyyyyyy
is 31 characters of the device ID. The
ANIUSB always responds with a 31
character device ID.
Get Firmware Version
Command String:
< GET FW_VER >
ANIUSB Response:
< REP FW_VER { yyyyyyyyyyyyyyyyyy } >
Where yyyyyyyyyyyyyyyyyy is 18
characters. The ANIUSB always responds
with 18 characters.
Get Preset
Command String:
< GET PRESET >
ANIUSB Response:
< REP PRESET nn >
Where nn is the preset number 01-10.
Set Preset
Command String:
< SET PRESET nn >
Where nn is the preset number 1-10.
(Leading zero is optional when using the
SET command).
ANIUSB Response:
< REP PRESET nn >
Where nn is the preset number 01-10.
Get Preset Name
Command String:
< GET PRESET1 >
< GET PRESET2 >
< GET PRESET3 >
etc
Send one of these commands to the
ANIUSB
ANIUSB Response:
< REP PRESET1
Where yyyyyyyyyyyyyyyyyyyyyyyyy is
25 characters of the device ID. The ANIUSB