Shure ANIUSB-Matrix - Page 28

9/12/17, 8)20 AMShure Publications | User Guides | ANIUSB-Matrix
Page 28 of 39http://pubs.shure.com/guide/ANIUSB-Matrix/en-US
ANIUSB Response:
< REP LED_BRIGHTNESS n >
Get Audio Clip Indicator
Command String:
< GET xx AUDIO_OUT_CLIP_INDICATOR
>
Where xx is ASCII channel number: 00
through 10.
ANIUSB Response:
< REP xx AUDIO_OUT_CLIP_INDICATOR
ON >
< REP xx AUDIO_OUT_CLIP_INDICATOR
OFF >
The ANIUSB will respond with one of these
strings.
Get Audio IP Address
Command String:
< GET IP_ADDR_NET_AUDIO_PRIMARY >
ANIUSB Response:
< REP IP_ADDR_NET_AUDIO_PRIMARY
{ yyyyyyyyyyyyyyy } >
Where yyyyyyyyyyyyyyy is a 15 digit IP
address.
Get Audio Subnet Address
Command String:
< GET IP_SUBNET_NET_AUDIO_PRIMARY >
ANIUSB Response:
< REP IP_SUBNET_NET_AUDIO_PRIMARY
{ yyyyyyyyyyyyyyy } >
Where yyyyyyyyyyyyyyy is a 15 digit
subnet address.
Get Audio Gateway Address
Command String:
< GET IP_GATEWAY_NET_AUDIO_PRIMARY
>
ANIUSB Response:
< REP IP_GATEWAY_NET_AUDIO_PRIMARY
{ yyyyyyyyyyyyyyy } >
Where yyyyyyyyyyyyyyy is a 15 digit
gateway address.
Get Limiter Status
Command String:
< GET xx LIMITER_ENGAGED >
Where xx is ASCII output channel number:
07 through 10. Indicates if the limiter is
currently reducing the signal level.
ANIUSB Response:
< REP xx LIMITER_ENGAGED ON >
< REP xx LIMITER_ENGAGED OFF >
The ANIUSB will respond with one of these
strings.