What to do if charger is not discovered by the Control Software of Shure Microflex MXWNCS4 system?
Ensure that the MXWNCS charger is not in High Efficiency Mode (solid blue Microphone Link LED) for Shure Microphone system.
How to fix no or distorted audio on Shure Microflex MXWNCS4 system?
To troubleshoot no or distorted audio on your Shure Microphone system: * Check the cables. * Ensure transmitters are on and channels are un-muted. * Verify the input meters are OK on the Monitor tab of the MXW control software, and attenuate if the channel is clipping. * Check the output meters on the Audio Network Interface (ANI) front panel and in the ANI control software. Use headphones to listen to the audio from the ANI, and attenuate if the channel is clipping. * Confirm that the output level of the ANI matches the input of the connecting equipment. * Verify APT is not performing a spectrum scan.
What to do if audio is cutting in and out on Shure Microphone system?
If the audio on your Shure Microphone system is cutting in and out, you can: * Perform a Spectrum Scan to monitor RF interference. * Decrease channel count to verify if the system is overloading the RF spectrum.
Why can't I connect to the Control Software from a PC for Shure Microflex MXWNCS4 system?
General| Charging Ports | USB-C |
|---|---|
| Dimensions | 100 x 100 x 30 mm |
| Weight | 0.5 kg |
| Color | Black |
| Compatibility | Shure Microflex Wireless |
| Networking Interface | Ethernet |
| Operating Temperature Range | 32°F to 104°F (0°C to 40°C) |
| Storage Temperature Range | -20°C to 60°C |
| Power Requirements | 5V DC |
To Next Page