Need help?Do you have a question about the Shure Microflex MX418D and is the answer not in the manual?
General| Type | Condenser |
|---|---|
| Polar Pattern | Cardioid |
| Output Impedance | 180 ohms |
| Power Requirements | 11-52 V DC phantom power (2.0 mA) |
| Connector | XLR |
| Boom Length | 18 inches |
| Frequency Response | 50 Hz - 17 kHz |
| Sensitivity | -33 dBV/Pa (22 mV) |
Highlights the wide dynamic range, interchangeable cartridges, programmable mute button, logic I/O, and RF filtering.
Explains how to choose polar patterns (Omnidirectional, Supercardioid, Cardioid) for different installations.
Provides instructions on aiming the microphone, noise control, and using automatic mixers.
Details differences in gooseneck length, mute button/LED, and surface mount flange models.
Describes the windscreen's function for 'pop' protection and how to attach/remove it.
Illustrates how to mount the microphone base to a surface using screws.
Explains how to use DIP switches (1-3) to set mute button function and logic controls.
Details the purpose of Logic Ground, LED IN, and SWITCH OUT terminals for external control.
Guides on connecting logic leads and setting DIP switches for mixer integration.
Describes a hardware modification to change SWITCH OUT behavior to momentary.
Lists detailed technical parameters including frequency response, sensitivity, SPL, noise, and dynamic range.
Details included items like windscreens and available optional accessories.
Identifies replacement cartridges (Omnidirectional, Supercardioid, Cardioid).
States compliance with EMC Directive and Harmonized Standards for environmental use.
To Next Page
