Shure P3RA Manual

Instruments
Vocals
Balance and Mix Adjustments from the Home Screen
To make quick adjustments to the stereo balance or MixMode blend, use the
arrow buttons (▲▼) while in the home screen. If necessary, use the lock
feature to prevent any accidental adjustments.
Shure SB900 Rechargeable Battery
Shure SB900 lithium-ion batteries offer a rechargeable option for powering
the bodypack. Batteries quickly charge to 50% capacity in one hour and
reach full charge within three hours.
Single chargers and multiple bay chargers are available to recharge the
Shure batteries.
Caution: Only charge Shure rechargeable batteries with a Shure battery
charger.
Single Bay Charger
The SBC-100 single bay charger offers a compact charging solution.
1. Plug the charger into an AC power source or USB port.
2. Insert a battery into the charging bay.
3. Monitor the charging status LEDs until charging is complete.
LED
StatusColor
ChargingRed
Charging CompleteGreen
Fault: check connections and batteryAmber Flashing
No battery in bayOff
Multiple Bay Chargers
Shure offers three models of multiple bay chargers:
• SBC200 two bay charger
• SBC210 two bay charger
• SBC800 eight bay charger
SBC200 chargers can charge individual batteries or batteries installed in
bodypacks.
1. Plug the charger into an AC power source.
2. Insert batteries or bodypacks into the charging bay.
3. Monitor the charging status LEDs until charging is complete.
StatusColor
Charging CompleteGreen
Charge level above 90%Green/Red
ChargingRed
Fault: check connections and batteryAmber Flashing
No battery in bayOff
Important Tips for Care and Storage of Shure
Rechargeable Batteries
Proper care and storage of Shure batteries results in reliable performance
and ensures a long lifetime.
• Always store batteries and bodypacks at room temperature
• Ideally, batteries should be charged to approximately 40% of capacity
for long-term storage
• During storage, check batteries every 6 months and recharge to 40% of
capacity as needed
Shure IncorporatedP3RA Professional Wireless Bodypack Receiver
5/72017/10/30

Shure P3RA Specifications

General

Display	LCD
Housing	Metal
Image Rejection	> 90 dB
Adjacent Channel Selectivity	>70 dB
Intermodulation Attenuation	>70 dB
Blocking	> 80 dB
Tuning Steps	25 kHz
Type	Bodypack
Frequency Range	470 - 952 MHz
Audio Output Power	100 mW (at 1 kHz, <1% distortion, typical)
Dimensions	99 mm x 66 mm x 23 mm
RF Frequency Range	470 - 952 MHz
RF Sensitivity	2.2 μV at 20 dB SINAD
Minimum Load Impedance	16 Ω
Headphone Connector	3.5 mm
Battery Type	SB900A
Audio THD	< 0.5%
Power Requirements	2 AA batteries or Shure SB900A rechargeable battery
Dimensions (inches)	3.9 x 2.6 x 0.9
Net Weight	196 g (with batteries)