Shure QLX-D Wireless System - Transmitter Features and Setup; Transmitter Components Identification; Battery Installation and Type Setting

7
Do Not Duplicate or Redistribute
Transmitters
① Power LED
• Green = unit is powered on
• Red = low battery
② On/Off Switch
Powers the transmitter on or off.
③ Display:
View menu screens and settings.
Press any control button to
activate the backlight.
④ IR window
Align with the receiver IR window
during an IR sync for automated
transmitter programming.
⑤ Menu Navigation Buttons
menu = Use to navigate between
menu screens.
▼▲ = Use to edit menu
parameters
enter = Press to confirm and save
parameter changes.
Tip: Press the menu button to exit without
saving parameter changes.
⑥ Battery Compartment
Requires 2 AA batteries or a Shure
SB900 rechargeable battery.
⑦ AA Battery Adapter
Secures batteries when powering
transmitter with AA batteries instead of
Shure SB900 battery.
⑧ Bodypack Antenna
For RF signal transmission.
⑨ Handheld Integrated Antenna
For RF signal transmission.
⑩ Microphone Cartridge
See Optional Accessories for a list of
compatible cartridges.
⑪ TA4M Input Jack
Connects to a 4-Pin Mini Connector
(TA4F) microphone or instrument
cable.
⑫ Battery Contact Cover
Align the cover as shown to prevent
reflections from the battery contacts
during broadcasts or performances.
on
ULXD2
⑩
②
④
⑤
⑥
⑦
③
⑪
ULXD1
①②
③
④
⑤
⑥
⑦
⑧
⑨
⑫
Battery Installation
Setting the AA Battery Type
When powering the transmitter with AA batteries, set the battery type in the transmitter menu to match the installed battery type to ensure accurate re-
porting of transmitter runtime. If a Shure SB900 rechargeable battery is installed, selecting a battery type is not necessary and the battery type menu will
not be displayed.
1. Press the menu button to navigate to the battery icon.
2. Use the ▼▲ buttons to select the installed battery type:
• AL = Alkaline
• nH = Nickel Metal Hydride
• Li = Lithium Primary
3. Press enter to save.
① Accessing the Battery Compartment
Press the side tabs on the bodypack or unscrew
the cover on the handheld as shown to access
the battery compartment.
AA Batteries Shure SB900 Battery
on
Bodypack Transmitter
n
o
2DXLU
1
2
on
AA Adaptor
AA Adaptor
② Installing Batteries
• AA Batteries: Place batteries (note polarity markings) and AA Adaptor as shown
• Shure SB900 Battery: Place battery as shown (note polarity markings), remove
AA Adaptor from bodypack transmitter, stow AA Adaptor in door for handheld
transmitter
Note: If using AA batteries, set the battery type using the transmitter menu.