Shure SR105 - Page 3

SR105 Power Amplifier
SPECIFICATIONS
(Curves shown are typical)
FREQUENCY (Hz1
OUTPUT POWER (WATTS)
TOTAL HARMONIC DISTORTION VS. OUTPUT POWER TO
4-OHM LOAD AT 50 HZ, 1 KHZ
& 10 KHz (DIRECT OUTPUT
ONLY)
OUTPUT POWER VS. FREQUENCY AT 1%
81 2% TOTAL HAR-
MONIC DISTORTION TO 4-OHM LOAD (DIRECT OUTPUT
ONLY)
LOAD RESISTANCE, OHMS
OUTPUT POWER (WATTS)
TOTAL HARMONIC DISTORTION VS. OUTPUT POWER (VAR-
IOUS LOADS) AT
1 KHz AND CONSTANT 70.7V OUTPUT
(70V OUTPUT ONLY)*
FREQUENCY ( H J
OUTPUT POWER (WATTS)
TOTAL HARMONIC DISTORTION VS. OUTPUT POWER TO
OUTPUT POWER VS. FREQUENCY AT 1%
& 2% TOTAL HAR-
150-WATT (33-OHM) LOAD AT 1 KHz FOR INCREASING OUT-
MONlC DISTORTION TO 33-OHM LOAD (70V OUTPUT ONLY)*
PUT VOLTAGES (70V OUTPUT ONLY)*
'Model SRIO~A only. iii