EasyManua.ls Logo

Shure SR110 - User Manual

Shure SR110
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
I
222
HARTREY
AVE..
EVANSTON. IL.
60204 U.S.A.
1
MODEL SR110 A)
.--
-
8
qD
MICROPHONES
AND
ELECTRONIC
COMPONENTS
I
1
UW
A
SRI 10-2E
PROFESSIONAL
AKtA
I;uUt
31ZIXbb.ZZUU
.
LAMLt:
bHuKtMILKU
I
SHEET
MONITOR MIXERS
I
I
TWX:
910-231-0048 TELEX: 72-4381
I
OPERATION AND
DESCRIPTION
The Shure Model SR110 Professional Monitor Mixer
is a rack-mounted, eight-channel, line level mixer, de-
signed as an accessory for the Shure Model
SRlO1
Series 2 Audio Console or SR109 Professional Mixer.
It can also be used with similar equipment when a
separate stage monitor mixer is desired to be added
to a sound reinforcement system. The
SR110 can also
be used in multi-track recording applications as a re-
cording mix panel or in stereo broadcasting.
Interconnections between the
SR110 and the SRlO1
or SR109 are made through a single multi-pin con-
nector and cable permanently attached to the SRllO.
The
SR110 also contains a matching female multi-pin
connector for "stacking" additional
SRllOs.
The SR110 provides eight high-impedance, unbal-
anced, line level inputs to its mixing circuitry, and one
high-impedance, unbalanced line level input to its
output selector switch for monitoring program mate-
rial. The output of the
SR110 is a 600-ohm balanced
line level with one three-pin male professional audio
connector and two standard
'/4
inch three-circuit
phone jacks, connected in parallel.
The front panel of the SRllO contains eight rotary
volume controls for channel gain, and a combination
rotary master volume controllpower-off switch. An
output selector slide switch, headphones jack and
neon power indicator lamp are provided. Silicon
transistors and other solid-state devices are used
throughout. All components are of the highest quality,
and are operated well within their respective ratings
to assure maximum reliability under normal use con-
ditions.
The
SR110 and SR110-2E are identical except that
the SRllO operates from 108-132 Vac, 50160 Hz, and
the
SRllO-2E operates from either 105-125 or 210-250
Vac, 50160 Hz (switch-selectable).
SR110 Mixers are supplied with four rack-mounting
screws for mounting in standard 19 in. (483 mm) audio
equipment racks or in an optional Shure
A105A Carry-
ing Case (mounted with an
SR109). In addition, the
SR110-2E is supplied with a detachable ac line cord
(without power plug). The
SRl10 (only) is listed by
Underwriters' Laboratories, Inc., and is listed by
Canadian Standards Association as certified.
SPECIFICATIONS
Type
.
. . . . .
.
. . .
. .
.
.All silicon transistor monitor
mixer
SERVICE MANUAL
Number of lnput
Channels
.
.
. . .
.
.
.8 mixed inputs; 1 program input
Power Output
. . . . .
.
+19.2 dBm (LINE LEVEL Output)
Voltage Gain*
Mixed
Inputs**
.
.
.
. . .
.38 i2.5 dB (LINE LEVEL Output)
14.5
t2.5 dB (PHONES Output)
-8
+-2
dB (MIX BUS)t
Program
Input**
. . . .
.
.
.
.40 +-2 dB (LINE LEVEL Output)
Frequency
Response
.
.
.
lnput Sensitivity
.
. .
Distortion
. .
. . . . .
.
.
Noise
(300 HZ-20
kHz)
Mixed
Inputs**
.
. . . . .
.
i3 dB, 20 Hz-20 kHz (LINE
LEVEL Output)
.21
mV max. for +4 dBm line
level output
.THD less than 1
%
at
+
12 dBm,
30 Hz-20 kHz; IM distortion
less than 1
%
at +12 dBm
.
-
68 dBV max. (MASTER
Volume Control down)
.
-54 dBV max. (MASTER and
channel Volume Controls up)
Program
Input**
.
.
.
.
.
.
.
.
-58 dBV max. (MASTER
Volume Control up)
Hum and Noise
(20 Hz-20 kHz)
. .
.
-
64 dBV max. (MASTER
Volume Control down)
Mixed
Inputs**
. . . . .
.
.
-50 dBV max. (MASTER and
channel Volume Controls up)
Program
Input**
.
.
.
.
. .
.
.
-54 dBV max.
(MASTER
Volume Control up)
lnput Clipping
Level at
1 kHz
.
.
.
.2.5V min. on mixed inputs 1-8
with channel Volume Controls
set at max. (input clipping
level increases with decreased
setting of channel Volume
Control)
lnput Impedance
at 1 kHz:
Mixed
Inputs**
.
.
. . . .
.23.5
kilohms
Program
Input**
.
.
. .
. . .
.30
kilohms
*Measurement conditions: Inputs through
150
ohms, LINE LEVEL output
terminated in
600
ohms,
PHONES
output terminated in
8
ohms,
MASTER
and channel Volume full up.
**OUTPUT SELECTOR
Switch position.
+MIX
BUS
terminated
in
5.6k.
Copyright 1979, Shure Brothers Inc
27A1291
(56)
Printed in
U.S.A.
Question and Answer IconNeed help?

Do you have a question about the Shure SR110 and is the answer not in the manual?

Shure SR110 Specifications

General IconGeneral
BrandShure
ModelSR110
CategoryMusic Mixer
LanguageEnglish

Summary

OPERATING INSTRUCTIONS

General Setup and Safety

Provides safety warnings and initial installation steps for the unit.

General Operating Instructions

Power Supply

Describes power supply specifications, connection, and voltage selection for the SR110/SR110-2E.

SPECIAL OPERATING INSTRUCTIONS

SERVICE INSTRUCTIONS

Safety Warning

Crucial warning about hazardous voltages and the need for qualified service personnel.

Replacement Parts and Cover Removal

Information on replacement parts and instructions for removing the unit's cover.

Service Procedures

Fuse and PCB Replacement

Instructions for fuse replacement and removing the printed circuit board for servicing.

Product Information

Replacement Parts List

A comprehensive list of replacement parts with designations, quantities, and descriptions.

Service and Troubleshooting

Troubleshooting Measurements

AC and DC Voltage Measurements

Details procedures for measuring AC and DC voltages at various points for troubleshooting.

Resistance Measurements

Outlines resistance checks for transformers, transistors, and diodes.

Related product manuals