Shure T series - Page 17

ENGLISH
16
T1, T1G AND T11 BODY-PACK TRANSMITTER SPECIFICATIONS
rf Output 50 mW Typical (T1, T1G); 20 mW Typical (T11)
Input Configuration Unbalanced
Connector Type 4-pin Tini QG (male)
Actual Impedance
1 MΩ
Maximum Recom-
mended Input Level*
+12 dBV
Minimum Recommended
Input Level**
–80 dBV
Connector Pin
Assignments
Pin 1:Tied to Ground
Pin 2:Tied to +5 V
Pin 3:Tied to Audio
Pin 4:Tied to 20kΩ Resistor and Audio Ground
Dimensions
(T1, T1G)
64 mm H x 106 mm W x 24 mm D
(2.52” H x 4.17” W x .95” D)
Dimensions (T11) 83 mm H x 64 mm W x 26 mm D
(3.25” H x 2.5” W x 1.03” D)
Net Weight (T1,T1G) 96.4g (3.4 oz.)
Net Weight (T11) 79.4g (2.8 oz.)
Power Requirements 9 V alkaline battery (Duracell MN1604 recommended);
8.4 V NiCd battery optional.
Nominal Current Drain 30 mA
* Gain Control at minimum
** Gain Control at maximum
T2 HAND-HELD TRANSMITTER SPECIFICATIONS
T2/58 (SM58) T2/31(BG3.1)
rf Output 50 mW Typical (FCC); 20 mW Typical (ETSI)
Dimensions 236 mm H x 51 mm D
(9.29” H x 2.01” D)
222 mm H x 51 mm D
(8.74” H x 2.01” D)
Net Weight 295g (10.4 oz.) 266g (9.4 oz.)
Power Requirement 9 V alkaline battery (Duracell MN1604 recommended); 8.4V
NiCd battery optional.
Nominal Current Drain 30 mA 30 mA
T3, T4 AND T4G RECEIVER SPECIFICATIONS
Connector 3-Pin XLR (Male) T4 and T4G 1/4” Phone Plug (Female) T3,
T4 and T4G
Maximum Output Levels –22 dBV –6.8 dBV
Nominal Output Levels –62 dBV –32 dBV
Output Configuration Active Balanced Unbalanced
Actual Impedance
500 Ω 1 kΩ
Connector Pin Assignments Pin 1: ground
Pin 2: hot
Pin 3: cold
Tip: hot
Sleeve: ground
Dimensions (T4, T4G) 36 mm H x 292 mm W x 103 mm D
(1.41” H x 11.50” W x 4.06” D)
Dimensions (T3) 35 mm H x 152 mm W x 98 mm D
(1.38” H x 5.98” W x 3.85” D)
Net Weight (T4, T4G) 416g (14.7 oz.)
Net Weight (T3) 192 g (6.8 oz.)
Power Requirements 12–18 Vdc nominal, 200mA
Power Supply 120 V or 230V ac adaptor with 2.1 mm female plug
Voltage/Current/Phantom
Power Protection
Yes Yes