Shuttle NC02U - Change User Password; Password Login control; Flash Write Protection; Secure Boot Control

17
English
appears. Type the password and press <Enter>. The screen does not display
the characters entered. Retype the password as prompted and press <Enter>.
If the password confirmation is incorrect, an error message appears. The
password is stored in NVRAM after BIOS completes.
Change User Password
Select Change User Password from the Security Setup menu and press
<Enter>.
Enter New Password:
appears. Type the password and press <Enter>. The screen does not display
the characters entered. Retype the password as prompted and press <Enter>.
If the password conrmation is incorrect, an error message appears. The pass-
word is stored in NVRAM after BIOS completes.
Password Login control
This item allows user to adjust Password Login control.

The choice: Setup, Boot, Both.
Flash Write Protection
Choose [Enabled] to avoid virus destroy BIOS. If you want to ash BIOS, you
must set it [Disabled].

The choice: Enabled or Disabled.
Secure Boot Control
This item allows user to enable/disable Secure Boot function.