EasyManuals Logo

Shuttle DS77U Series User Manual

Shuttle DS77U Series
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This device meets the requirements for the EU conformity in accordance to the currently valid EU directives.
Dieses Produkt erfüllt die Anforderungen für die EU-Konformität entsprechend der aktuell geltenden EU-Richtlinien.
Ce produit répond aux exigences de la conformité UE suivant les directives européennes actuellement en vigueur.
All bundled parts, included power cord, cannot use without this product.
󵤫󳃀󰈯󰉺󰉔󰉩󳵹󰆍󰇝󰇽󰇪󰇲󱄈󱺎󱛱󰇳󲥜󲲏󱄕󱭆󰇫󰇳󰇘󱆯󳝘󰇯󰇮󰈐󰈂󰇟󰈗󰆎
b
a
DS77U Series Quick Guide
󲈛󷀗󶛙󶻃󲔷󱖇󰆌
Kurzanleitung
󰆌
Guide rapide
󰆌
Guía rápida
󰆌󰈭󰈢󰉁󰈭󰈪󰈢󰉇󰆌
Kраткое руководство
󰆌󲈛󷀗󶛙󴫵󲔷󱖇
For safety reasons, please ensure that
the power cord is disconnected before
opening the case.
53R-DS77U3-2001
L
The product’s colour and specifications may vary from the actually shipping product.
A. Begin Installation
!
a
b
Hardware Installation
󳪜󵴄󶛙󶻃
󰉍󰉺󰉇󰈤󰈥󰈠󰇲󰈢󰉱󰈷󰉆󰉺󰉩 󳪜󱄦󶛙󴫵
1. USB 3.1 Gen 1 Ports
2. USB 2.0 Ports
3. Power LED
4. HDD LED
5. Power Button
6. SD Card Reader
7. COM 1 Port (RS232/RS422/RS485)
8. COM 2 Port (RS232 only)
9. External Power SW & Clear CMOS
10. DisplayPort (Without Audio/Hotplug)
11. HDMI Ports
12. MIC-in
13. Headphones
14. LAN Ports (Gigabit LAN)
15. Power Jack (DC IN)
16. Kensington
®
Lock Hole
3 6
14 15
9
10 11 12 13
16
16
1 2 4 5 7 8
2
1. Unscrew the two screws of the chassis
cover. Slide the cover backwards and
upwards.
1. Unfasten the rack mount screw and remove the rack.
B. HDD or SSD Installation
2. Place an HDD or SSD in the rack and secure
with two screws from each side.
3. Lay the HDD or SSD into its drive bay
and push it gently to the right until it
clicks into place. Refasten screws.
Please press the "Del" key while booting to enter BIOS. Here, please load the optimised BIOS settings.
Operation Position: Please make sure to use either the supplied feet or the VESA mount.
!
Incorrectly replacing the battery may damage this computer.
Replace only with the same or equivalent as recommended by Shuttle.
Dispose of used batteries according to the manufacturer’s instructions.
󲤤󲘋󵤫󲺐󲟩󲄿󵕟󴳔󱘟󴌭󲤳󲘽󱬎󲥜󵤫󴎖󱄕󱗺󲅅󳢬󳐶󳋨󰆍󳊛󳊭󲑆󱎦󱄆󱖡󵣚󰆎
󱋵󴌭󱇍󳢴󲄪󴶠󱄕󳤨󱘼󲑆󱘼󳵹󳢴󵤫󲺐󲤤󲘋󰆎󴳻󱇍󳎗󴬭󵉐󱝶󳢴󱆯󳝘󴳚󲠾󴢅󳘶󲄒󵤫󲺐󰆎
Das unkorrekte Austauschen der Batterie kann diesen Computer beschädigen.
Ersetzen Sie die Batterie nur durch den von Shuttle empfohlenen Typ oder ein gleichwertiges Modell.
Entsorgen Sie gebrauchte Batterien gemäß den Herstellerangaben.
Ne pas replacer correctement la pile peut endommager l'ordinateur.
Remplacez-la uniquement par un modèle identique ou un équivalent comme recommandé par Shuttle.
Débarrassez-vous des piles usagées d’après les instructions du constructeur.



󰉎󰉁󰉄󰉨󰈖󵟃󵊅󰇧󰇪󰈹󰉁󰉆󰇝󰈏󰇬󰆍󰇗󰇲󰈱󰉱󰉒󰉣󰉺󰈽󰇐󲘽󱋧󰇝󰈏󱗏󱤐󰇬󰇮󰈎󰈂󰇝󰆎
󱃔󲘋󰇝󰈏󵣋󰇳󰆍󰇐󲗘󱮘󰇝󰈏󰉎󰉁󰉄󰉨󰇬󱘼󰇜󰈆󰇲󰈂󰇣󰇳󱘼󳵹󰇲󰈆󰇲󰇤󰇕󰈖󱆯󳝘󰇝󰈏󰈌󰇊󰇯󰇛󰇪󰇓󰇤󰇙
󰇈󰆎󱆯󳝘󳀸󰈃󰉎󰉁󰉄󰉨󰇳󰆍󰉟󰉺󰈩󰉺󰇲󲔷󳭪󰇯󲇃󰇧󰇪󱐖󱐶󰇛󰇪󰇓󰇤󰇙󰇈󰆎



󲤤󲖒󳝥󲺐󲟩󲄿󵝉󴸟󱘟󴌭󱅊󲖏󱥿󲥜󳝥󴍁󰆎󱃵󴌭󱇍󳢴󲄪󴷞󱄕󳤨󱘼󲑆󱘼󳵹󳢴󳝥󲺐󲤤󲖒󰆎
󴸧󱇍󳎗󱑦󵉐󱝶󳢴󱆯󳝘󴸤󲠾󱬴󳘶󲃏󳝥󲺐󰆎
!
Safety Information
󶛙󶇰󴻷󶻽
󶛙󶇰󰇯󵟒󰇝󰈏󲋵󶙷󶛙󶇰󶖆󲊟
E. Complete
1. Please replace and affix the case cover with two screws.
2. Turn your DS77U upside down and connect the power cord.
3. Complete.
DC-IN
e
f
d
1. Locate the SO-DIMM slots on the motherboard.
2. Align the notch of the memory module with the
one of the relevant memory slot.
3. Gently insert the module into the slot in a
45-degree angle.
4. Carefully push down the memory module
until it snaps into the locking mechanism.
5. Repeat the above steps to install an
additional memory module, if required.
D. M.2 Device Installation
C. Memory Module Installation
Latch
Latch
Notch
Cutout
SO-DIMM slot
45-degree
angle
This motherboard does only support 1.2 V DDR4 SO-DIMM memory modules.
!
a
b
M.2 2242/2260/2280 M key slot
a
b
Slope angle
1. Locate the M.2 key slots on the motherboard, unfasten the screw first.
2. Install the M.2 device into the M.2 slot and secure with the screw.
c
a
b
b
a
2.5 inch HDD/SSD Slot
c
a
c
More information on this product can be found at: http://bit.ly/DS77USERIES
󲤤󱭊󲥜󳝒󱛱󴻷󶻽󰦉󶽋󴛎󴐘󰦗
http://bit.ly/DS77USERIES
Weitere Informationen zu diesem Produkt finden Sie unter: http://bit.ly/DS77USERIES
Pour plus d'informations sur ce produit, visitez: http://bit.ly/DS77USERIES
Puede encontrar más información sobre este producto en: http://bit.ly/DS77USERIES
󲥜󶻍󱛱󰇲󶼩󶰌󰇮󲋵󶙷󰇯󰇨󰇈󰇪󰇳󰆍󲵑󰇲
URL
󰈌󰈎󶭉󶼲󵨲󰇕󰈂󰇝󰆎
http://bit.ly/DS77USERIES
Для получения дополнительной информации об этом продукте перейдите по ссылке:
http://bit.ly/DS77USERIES
  
󲤤󱭊󲥜󱃗󱛱󶖆󲊟󰦉󴸧󴷯󵠞󰦗
http://bit.ly/DS77USERIES
Product Overview
󳝒󱛱󶚗󶻵󶻍󱛱󶤮󴮱󱃗󱛱󶚗󴯲
b

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Shuttle DS77U Series and is the answer not in the manual?

Shuttle DS77U Series Specifications

General IconGeneral
GraphicsIntel HD Graphics 610
ProcessorIntel Celeron 3865U, Dual Core, 1.8 GHz
Memory2 x SO-DIMM slots, DDR4-2133, up to 32 GB
Storage1 x 2.5" HDD/SSD bay (height up to 9.5 mm), 1 x M.2 2280 Type M slot (SATA)
AudioRealtek ALC662
EthernetIntel i211, 10/100/1000 Mbps
Front Panel2 x USB 3.0, Microphone-in, Headphone-out
Rear Panel2 x USB 2.0
Operating SystemWindows 10, Linux
CoolingFanless
Video OutputsHDMI, DisplayPort
Dimensions200 x 165 x 39.5 mm

Related product manuals