Sices DST4600A - Alarms; Low Oil Pressure Alarm; High Cooling Water Temperature Alarm

16 User’s Manual
Disabling
Bit 2 of Parameter P39 = 0
Conditions to activate it
Engine running from the time set through the parameter P31
Digital input “OIL WARNING” (terminal 08) shorted to ground
Fuel solenoid activated.
Not existent in asynchronous engine version
Filter time
2 seconds
Visual signal
Quick flashing of the indicator “LOW OIL PRESSURE”
Disabling
Parameter P47 = 0 and/or parameter P25 = 0
Conditions to activate it
Engine running from the time set through the parameter P31
Pressure detected by the analogue input “OIL PRESSURE”
(terminal 42) lower or equal to the threshold set through the
parameter P25
Fuel solenoid activated.
Filter time
2 seconds
Visual signal
Quick flashing of the indicator “LOW OIL PRESSURE”
Disabling
Bit 0 of the Parameter P39 = 0
Conditions for its
activation
Fuel solenoid closed (output “FUEL SOLENOID”, terminal 22
enabled)
Digital input “TEMP. WARNING” (terminal 10) shorted to
ground
Filter time
2 seconds
Visual signal
Quick flashing of the indicator “TEMPERATURE”
Disabling
Parameter P46 = 0 and/or P26 parameter = max
Conditions for its
activation
Fuel solenoid closed (“FUEL SOLENOID” output, terminal 22
enabled)
Temperature detected from the analogue input
“TEMPERATURE” (terminal 43) over or equal to the threshold
set through the parameter P26
Filter time
2 seconds
Visual signal
Quick flashing of the indicator “TEMPERATURE ”