Sices DST4601/PX - Page 8

8 User’s Manual
Signalling
Function
MAINS LIVE

Mains power is OFF or MAINS SIMULATION digital input is disabled.

Mains power is ON and stable in the range of tolerance, or MAINS
SIMULATION digital input is enabled from the set time.

Flashes at 50% during transition between the previous two states.
GENERATOR
LIVE

Generator voltage and frequency are not present.

Generator voltage and frequency are present and stead within the
tolerance range.

Flashes at 50% during transition between the previous two states.
ENGINE
RUNNING

The engine is OFF.

The engine is running

Cooling phase
MCB

The MCB is open.

The MCB is closed

Flashes at 25% ON if open after a closing command.
Flashing at 75% ON if the KG is closed after an opening command.
Flashing at 50% in synchronization phase with BUS LIVE indicator.
GCB

The MCB is open.

The MCB is closed

Flashing at 25% ON if the KG is open after a closing command.
Flashing at 75% ON if the KG is closed after an opening command.
Flashing at 50% in synchronization phase with BUS LIVE indicator.
The backlight lamp is managed by Gen-set, which switches it off after a programmable time
(P.492) if no buttons are pressed in the meantime. Press any button to switch the lamp ON
again, (we recommend using the SHIFT button as it has no function when used alone).
This function can be disabled by setting parameter P.492 to 0.
The contrast can be adjusted by pressing the SHIFT + LEFT buttons to decrease
the contrast or the SHIFT +RIGHT buttons to increase it.