Sices GC310 - Page 19

GC310, GC350, GC500, GC500Plus and GC500Mains User’s Manual 19
Display screen B.03 and press the ACK/ENTER button and the LEFT and RIGHT
buttons to select either "requested power" and/or "required cosfi (power factor)"; press the
UP Ref. 1a button to increase the value and the DOWN Ref. 1a button to decrease the set
percentage value (%). The value to be changed is highlighted in reverse.
Press the ACK/ENTER button to exit the adjustment procedure.
Note: The described function is only available if no external potentiometer has been configured for power
regulation.
4.
4.1
Gen-set can display messages in various languages.
To select a different language use the UP Ref. 1b and DOWN Ref. 1b buttons to access the
OFF/RESET mode and, while the card is powered, press contemporarily the STOP and START
buttons until the display shows the following message:
Special Function
Function [LANGUAGE]
Press the ACK/ENTER button and press ACK/ENTER once more; you will be prompted to enter
a password.
Press the ACK/ENTER button and use the UP Ref. 1a and DOWN Ref. 1a vertical scroll
buttons to set a password value to 1. Press again the ACK/ENTER button to confirm.
When a proper password is entered, the language selection page will be displayed.
Press the ACK/ENTER button and use the UP Ref. 1a and DOWN Ref. 1a vertical scroll
buttons to set the desired language; press ENTER to confirm.
To exit the special mode, power down Gen-set, wait for a few seconds, then power it up again.
Note:in this phase do not press the STOP and START buttons.