Need help?Do you have a question about the SICK C4P-SA12031A00 and is the answer not in the manual?
General| Brand | SICK |
|---|---|
| Model | C4P-SA12031A00 |
| Category | Safety Equipment |
| Language | English |
Provides general safety warnings and precautions regarding integration and electrical hazards.
Explains LEDs on sender and receiver for status indication.
Explains the necessity and calculation of minimum safety distances.
Provides formulas and examples for calculating minimum safety distances.
Addresses how to prevent reaching over the protective field.
Explains how to maintain safe distances from reflective surfaces.
Details methods for determining safe distances using graphs/formulas.
Discusses preventing interference between multiple light curtains.
Explains using beam coding to avoid interference.
Provides instructions on using beam coding.
Explains how to use reversed transmission to avoid interference.
Describes combining coding and transmission for multiple systems.
Covers the electrical integration of the safety light curtain.
Outlines requirements for signal analysis and controller integration.
Explains the restart interlock function and its implementation.
Covers prerequisites and connection for integrated restart interlock.
Explains EDM function, prerequisites, and operation.
Describes checks performed during commissioning and after changes.
Details periodic checks for ensuring safety function.
Explains how to perform a test rod check for verification.
Provides safety precautions related to mounting.
Covers general installation guidelines and precautions.
Safety precautions for electrical installation work.
Illustrates correct and incorrect OSSD connection methods.
Explains how to prevent potential differences in connections.
Provides step-by-step instructions for resetting to factory settings.
Explains how to configure beam coding using DIP switches.
Provides steps to configure the restart interlock.
Explains how to configure external device monitoring.
Safety precautions to consider before and during commissioning.
Details the process of aligning the sender and receiver.
Provides detailed steps for aligning sender and receiver.
Step-by-step guide for sender/receiver alignment.
Explains how LEDs indicate alignment status.
Specifies checks for commissioning and after modifications.
Safety precautions during operation.
Outlines checks to ensure the hazardous area is monitored.
Describes LED indicators on the sender and receiver.
Explains how to clean the safety light curtain and associated parts.
Details how to perform a regular thorough check.
Safety precautions during troubleshooting.
Explains LED indications during normal operation.
Explains how LEDs indicate different types of faults.
To Next Page
