SICK EtherCAT SIG350

4 Transport and storage
4.1 Transport
For your own safety, please read and observe the following notes:
NOTE
Damage to the device due to improper transport.
■
The device must be packaged for transport with protection against shock and
moisture.
■
Recommendation: Use the original packaging as it provides the best protection.
■
Transport should be performed by specialist staff only.
■
The utmost care and attention is required at all times during unloading and
transportation on company premises.
■
Note the symbols on the packaging.
■
Do not remove packaging until immediately before you start mounting.
4.2
Transport inspection
Immediately upon receipt at the receiving work station, check the delivery for complete‐
ness and for any damage that may have occurred in transit. In the case of transit
damage that is visible externally, proceed as follows:
■
Do not accept the delivery or only do so conditionally.
■
Note the scope of damage on the transport documents or on the transport compa‐
ny’s delivery note.
■
File a complaint.
NOTE
Complaints regarding defects should be filed as soon as these are detected. Damage
claims are only valid before the applicable complaint deadlines.
4.3 Storage
Store the device under the following conditions:
■
Recommendation: Use the original packaging.
■
Do not store outdoors.
■
Store in a dry, dust-protected place.
■
To allow any residual dampness to evaporate, do not package in airtight contain‐
ers.
■
Do not expose to aggressive substances.
■
Protect from sunlight.
■
Avoid mechanical shocks.
■
Storage temperature: see "Technical data", page 71.
■
Relative humidity: see "Technical data", page 71.
■
For storage periods longer than 3 months, regularly check the general condition of
all components and the packaging.
TRANSPORT AND STORAGE 4
8027836./2022-06-10 | SICK O P E R A T I N G I N S T R U C T I O N S | Sensor Integration Gateway - SIG350
15
Subject to change without notice