SICK EtherCAT SIG350

Figure 3: Mounting the module
Mounting
•
Position M6 screw in the upper mounting opening and tighten lightly.
•
Align housing
•
Position another M6 screw in the lower mounting opening and tighten lightly.
•
Tighten both screws with a max. tightening torque of 3Nm.
•
Ground module: see "Mounting of functional earth", page 17.
5.3 Mounting of functional earth
The module must be grounded to a metal base via a ground strap. To ensure functional
earth, the module must be mounted with conductive screws. The fixing screws and
tightening torques depend on the substrate of the mounting location. Always tighten the
screws carefully and observe the maximum permissible tightening torque of 1.2Nm.
NOTE
The ground strap and the associated screws for the functional earth are not included
with delivery. This set is available as an accessory (part number 5346121).
MOUNTING 5
8027836./2022-06-10 | SICK O P E R A T I N G I N S T R U C T I O N S | Sensor Integration Gateway - SIG350
17
Subject to change without notice