Need help?Do you have a question about the SICK i14 Lock and is the answer not in the manual?
General| Supply voltage | 24 V DC |
|---|---|
| Connectivity | Wired |
| Keyway | Not applicable |
| Connection type | M12 connector |
| Enclosure rating | IP67 |
| Lock Type | Solenoid interlock |
| Battery Life | Not applicable |
| Material | Metal |
| Type | Electromechanical safety lock |
Stresses that the safety locking device must be configured and operated by qualified personnel per machine requirements.
Defines the device's function with movable guards to prevent opening during dangerous machine functions, and notes suitability for process protection.
Details the necessary expertise for project planning, installation, commissioning, and operation/maintenance personnel.
Details the procedure for manual unlocking, including actuation steps and warnings about permanent actuation.
Warns against unexpected machine starting and bypassing the protective device, detailing prevention methods.
Details inserting the actuator, connecting the safety switch and actuator, and fitting an additional stop for the moving part.
Highlights the critical need to disconnect power supply during installation to prevent hazards from electrical voltage.
Details mechanical and electrical functional tests to verify proper operation after installation and following any faults.
Emphasizes regular checks to maintain effectiveness, prevent wear/damage, and indicates replacing the entire device if needed.
To Next Page
