2 Safety information
2.1 General safety notes
2.1.1 Safety notes
■
Read the operating instructions before commissioning.
■
Connection, mounting, and setting may only be performed by trained specialists.
■
Not a safety component in accordance with the EU Machinery Directive.
■
When commissioning, protect the device from moisture and contamination.
■
These operating instructions contain information required during the life cycle of
the gateway.
CAUTION
This equipment is not intended for use in residential environments and may not provide
adequate protection to radio reception in such environments.
2.2 Notes on UL approval
UL Environmental Rating: Enclosure type 1
2.3 Correct use
The SIG200 (hereinafter referred to as "module") is an IO-Link master for connecting IO-
Link devices and standard input signals or output signals. This data can be transmitted
to a higher-level system via Ethernet (REST API).
Intended use requires that the device is used industrially indoors without any spe‐
cific climatic and atmospheric requirements. Operation of the device according to its
intended use and enclosure rating IP 67 are only guaranteed if open male and female
connectors are sealed with blind plugs.
If the product is used for any other purpose or modified in any way, all warranty claims
against SICK AG will be void.
SAFETY INFORMATION 2
8024482.1FJ7 /2022-05-31 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
5
Subject to change without notice
To Next Page
Loading...
