EMC
- Immunity
- Emission
- EN 61000-6-2
- EN 61000-6-4
CAUTION
This equipment is not intended for use in resi‐
dential environments and may not provide ade‐
quate protection to radio reception in such
environments.
Shock / shaking EN 60068-2-6, EN 60068-2-27
Electrical data
Power supply 10 ... 30 V DC
Power Supply IO-
Link
18 ... 30 V DC
Voltage ripple < 1 %
Device (Power
Port)
Max. device current (without con‐
nected sensors)
≤ 175 mA @ 24 V
Max. device current
1
≤ 3,000 mA
Port (S1-S4) Pin 1 max. supply current
2
500 mA
Pin 4 max. output supply current
3
200 mA
Pin 4 output characteristics V
H
≥ V
US
- 3 V
Pin 2 input characteristics Type 3 IEC 61131-2
Pin 4 input characteristics Type 1 IEC 61131-2
1
The sum of all ports including digital outputs must not exceed the maximum device current. Current
needs to be limited.
2
Max. port current includes both the digital current output (Pin 4) and the connected device's current
consumption (Pin 1).
3
Pin 4 configured as digital output. Maximum output supply current is independent of Pin 1.
Ethernet
Ethernet interface 2x100 Base-Tx (switched)
Cable type acc. to IEEE 802.3 Min. STP CAT 5 / ST CAT 5e
Data transmission rate 100 Mbits/s
Max. distance between nodes 100m
Flow control Half Duplex / Full Duplex (IEEE 802.33x
Pause)
Used Ethernet protocols ICMP, TCP, UDP
Open TCP ports 80 (HTTP), 2111/2113/2122 (SOPAS)
Open UDP ports 1900 (UPNP)
Further information:
Initialization time after switch on: 70 s, if no iodd file installed
80 s maximum, if iodd is installed on each port
IODD upload time 40 s for USB connection and 20 s for Ethernet
connection (typical time for 150 kB file size)
Max. number of I/Os which can be connected: 52 I/Os (together with 4 SIG100)
Max. number of IO-Link signals which can be
connected:
4
Ethernet Ports: 2
TECHNICAL DATA 12
8024482.1FJ7 /2022-05-31 | SICK O P E R A T I N G I N S T R U C T I O N | Sensor Integration Gateway - SIG200
95
Subject to change without notice
To Next Page
Loading...
