Sicma S.p.A.
Miglianico (CH)
page 15
To connect the shredder to the front PTO of the tractor, proceed as follows:
- Loosen the (A) bolts that locks the tube into place and place them on the rear connection
(Pic.1-3)
- (B) unscrew the bolt that locks the rod cylinder (hydraulic or manual) (Pic.1)
- (C) unscrew the bolts that the plate with the kip together (Pic.2)
- properly anchor the mobile arc tube and cylinder to prevent it falling gearbox
- slip off the pipe (D), the cylinder (E) (fig.1)and the plate (F) (Pic.2)
- rotate 180° in those parts (Pic.3)
- reposition their respective offices at the rear of the shredders
- tighten the bolts
The steps must be performed in reverse order to shift from front to back
Pic. 1
Pic. 2
Pic. 3
To Next Page
Loading...
