Sicma S.p.A.
Miglianico (CH)
page 25
- Before injecting lubricating grease into the nipples, clean
them accurately to prevent mud, dust or other foreign
matters from mixing up with grease, thus diminishing the
lubrication effect
- When making oil feed or change it is better to use the
same oil type, in order to avoid mixing oils with different
features.
- When executing maintenance activities, keep the machine
rested on the ground in horizontal position.
- After the first working hours check that all bolts and nuts
are tightened strongly; remember also to check often all
the machine safety guards.
MAINTENANCE OF THE MACHINE
FIRST CHECK
• Check the correct tension of the driving belt
• Check that all bolts and nuts are tightened strongly
• After the first 50 hours of work change oil in the overgear unit (oil type: TOTAL
TRANSMISSION TM 80W90)
EVERY 8 HOURS OF WORK
• Grease the shaft support (driveline side) through the lubricating nipple A (picture 6)
• Grease the shaft support (external side) through the lubricating nipple A (picture 7)
• Grease the stabilizing roller through the lubricating nipple A (pictures 8-9)
EVERY 50 HOURS OF WORK
• Check the correct tension of the driving belt
• Check that all bolts and nuts are tightened strongly
• Check the cutters/hammers wear state
• Check the overgear unit oil level through plug A (picture 10)
EVERY 500 HOURS OF WORK
• Check that all bolts and nuts are tightened strongly
• Change oil in the overgear unit (oil type: TOTAL TRANSMISSION TM 80W90)
EVERY 1000 HOURS OF WORK
Replace the driving belts
To Next Page
Loading...
