10
2955
8 2020
-
RCT 20E, 21E, 22E, 23E & REMOTE RECEIVER
Programming Additional Transmitters/ Remote Controls
EN
The original transmitter and receiver have the same factory preset code so that no programming is necessary. When additional transmitters
remote controls are to be used, the additional transmitters/remote controls have to be paired with the receiver.
1. Be sure that there is power on the receiver (Green status LED blinking) and that the transmitter that should be paired is off .
2. Push the Pair Button on the receiver to put the receiver in pairing mode (as shown above). Both red and green led’s should start to blink
simultaneously.
3. Within 10s after the receiver pair button is pushed, set the transmitter in pairing mode by holding the off button and pressing both “ON” buttons
at the same time, all the transmitter LED’s turn on indicating that it is set in pairing mode. When a pairing signal is received from the receiver the
transmitter LED’s while turn off and the system is ready to be used. If no pairing signal received within 10s the transmitter will leave the pairing
mode.
4. Additional transmitters/remote controls must be programmed according to step 2-3. You can pair up to 4 transmitters/remote controls.
5. To clear all transmitters/remote controls paired with the receiver hold the pair button on the receiver for approximately 10s until the red and green
led stop blinking. When the LED’s stop blinking release the pair button, the green led will again start to blink when the receiver has completed
the reset process. The receiver is then ready to pair with up to four transmitters/remote controls. Take time to practice operation in open water to
become familiar with the thruster and to avoid damages to your boat or people.
MC_0181
! Please refer to the graphic for special considerations relating to your model !
MG_0197
Pair Button
Pair Button
Pair Button
Pair Button
MG_0193
Mount the receiver
by using the 4 holes
To Next Page
Loading...