Side-Power RCR-2E - Receiver Installation; Installation Guidelines and Considerations; Power Supply and Wiring Requirements

7
2955
8 2020
-
RCT 20E, 21E, 22E, 23E & REMOTE RECEIVER
MG_0191
112
145
118
4
7
110
15
38
107
21
97
57
45
83
36
47
136
Ø 4.5
Ø 3
Ø 3
Receiver Installation
EN
• Install the receiver minimum 1 meter (3ft) from high power cables and data communication cables or other sources of electrical interference, i.e.
navigation instruments, radio communication devices, electric motors and generators.
• Install the receiver minimum 1 meter (3ft) above sea level.
• Install the receiver outside of shielded areas for radio signals, i.e. boxes made of metals or other material with shielding properties.
• Install the receiver in a dry environment, where no condensation can enter the unit. (The receiver assembly is not waterproof.).
• Mount the receiver using the four holes.
• The receiver must have a separate power supply  tted with a 5 Amp fuse in the positive lead that has either a separate power switch or is shut off
by the thrusters system main power switch. The receiver can not be powered by the thrusters/windlass control looms even if you  nd positive and
negative lead there.
• Connect the supplied wiring harnesses to the receiver unit according to the wiring diagram. Connect thrusters and windlasses to the appropriate
connectors according to the diagram.
• For use with other windlass brands, connections must be determined by the installer according to the out put signals diagram.
NB: Max. load on the windlass signal output is 4A! If the windlass requires more than 4A, use extra control relay.
MC_0177
! Please refer to the graphic for special considerations relating to your model !
IMPORTANT
Remote receiver power supply negative lead must be connected to the thrusters’ negative lead. Bow and stern thruster must have a
common negative. Power to the thrusters must be switched off during installation!
MG_0193
Mount the receiver
by using the 4 holes