Side-Power RCR-2E - S-Link Receiver Installation; S-Link Installation Guidelines

11
2955
8 2020
-
RCT 20E, 21E, 22E, 23E & REMOTE RECEIVER
MG_0197
Pair Button
Pair Button
Pair Button
Pair Button
S-Link Receiver Installation
EN
• Install the receiver minimum 1 meter (3ft) from high power cables and data communication cables or other sources of electrical interference, i.e.
navigation instruments, radio communication devices, electric motors and generators.
• Install the receiver minimum 1 meter (3ft) above sea level.
• Install the receiver outside of shielded areas for radio signals, i.e. boxes made of metals or other material with shielding properties.
• Install the receiver in a dry environment, where no condensation can enter the unit. (The receiver assembly is not waterproof.).
• Mount the receiver using the four holes.
• The receiver is powered by the S-link cable.
• Connect the supplied wiring harnesses to the receiver unit according to the wiring diagram. Connect thrusters and windlasses to the appropriate
connectors according to the diagram.
• For use with other windlass brands, connections must be determined by the installer according to the out put signals diagram.
MC_0183
! Please refer to the graphic for special considerations relating to your model !
MG_0193
Mount the receiver
by using the 4 holes