Need help?Do you have a question about the Siemens 1LE0 and is the answer not in the manual?
Describes the intended use, environmental conditions, and compliance of 1LE0 motors.
Details the self-ventilation (TEFC) and forced ventilation cooling types for 1LE0 motors.
Illustrates various mounting types (IM B3, IM V5, etc.) and their corresponding frame sizes.
General principles for proper installation, emphasizing foundation and alignment.
Specifies flatness requirements for supporting surfaces based on motor frame size.
Details the need for checking and shimming clearance between motor feet and foundation.
Guidance on using lifting eyes and protective measures for shaft orientation during installation.
Critical warnings and guidelines for maintaining proper ventilation and preventing ingress of foreign objects.
Describes the mounting and rotation capabilities of the terminal box for cable entry.
Emphasizes proper alignment and balancing of coupled transmission elements for vibration-free operation.
Instructions for connecting power, earthing, and direction of rotation, including voltage/frequency deviations.
Illustrates the wiring configurations for star and delta connections of motor windings.
Details available electrical protection options (PTC, PT100, PT1000) for motor windings.
Explains connections for winding protection sensors and optional heaters.
Procedures for measuring insulation resistance after storage and acceptable values.
Importance of temperature monitoring, methods for measurement, and safety warnings.
Discusses variable torque applications, EMC, and effects of converter-fed operation on noise and vibration.
Average bearing life hours for different motor types and factors affecting it.
Specifies the recommended grease type and notes on mixing different greases.
Provides guidance on grease change intervals based on frame size, poles, and operating conditions.
Step-by-step instructions and safety precautions for re-greasing motor bearings.
Guidelines for replacing bearings, including disassembly, assembly, and tightening torques.
Information on the location and purpose of condensation drain holes and plugs.
Explains compliance with RoHS directives regarding hazardous substances in products.
Details substances in the product subject to REACH regulation, specifically lead.
Steps and safety rules for preparing the machine for disassembly and disposal.
General procedures for dismantling the machine and safety warnings about falling parts.
Guidance on sorting and recycling various machine components and materials.
Instructions for sorting and disposing of process materials, chemicals, and used cloths.
Guidelines for the disposal and recycling of wooden and foil packaging materials.
To Next Page
General