8
en
Congratulations on purchasing this
Siemens appliance. You have acquired
a high-quality product that will bring
you a lot of enjoyment.
Parts and operating
controls
1 Kettle (with water level indicator)
2 Lid with lock
3 O / I ON/OFF switch, illuminated
4
5 Base
6 Cable tidy
Important: Use the kettle 1 only with its
included base 5.
Milk and
instant beverages will burn and damage
the appliance. Never operate the kettle
1
observe the min and max markings. If
the kettle is too full, the water will boil
over!
Before using
Unroll the right amount of cable from the
cable tidy 6 and plug it in.
Fill the kettle 1 with water. Bring the water
to a boil and discard it. Repeat the proce-
dure. This will make sure that the kettle is
clean for normal use.
When the water comes to a boil for the
vinegar.
Boiling water
Remove the lid 21 with
fresh water through the opening or spout.
Read the quantity on the water level indi-
or more than 1,7 litres of water!
Put on the lid 2 at the mark and twist
to to lock it in place.
Press down the O / I ON/OFF switch 3;
the switch lights up. The water is heated.
the water has boiled.
any time by pulling up the O / I ON/OFF
switch 3.
Warning: If you remove the kettle 1 from
the base and replace it before the heating
process is over, the kettle will not continue
to heat the water.
N.B.: Only operate the kettle with the lid 2
4 inserted,
For physical reasons, the base 5 may
collect some condensation water. This is
normal; it does not mean that the kettle 1
leaks.
After boiling, let the kettle cool down for
Do not turn on the appliance if the kettle 1
is empty, otherwise the overheat control will
engage and the appliance will switch itself
To Next Page
Loading...
Need help?
General
